Toyota RAV4 Service Manual: Data list / active test

Toyota RAV4 Service Manual / 2Az-fe engine mechanical / Sfi system / Data list / active test

Fail-safe chart

If any of the following dtcs are set, the ecm enters fail-safe mode to allow the vehicle to be driven temporarily. Hint: *: The vehicle can be driven slowly when the accelerator pedal is depre ...

Hint: By reading the data list displayed on an intelligent tester, values can be checked, including those of the switches, sensors, and actuators, without removing any parts. Reading the data list ...

Other materials:

Assist grips
An assist grip installed on the ceiling can be used to support your body while sitting on the seat. Caution Assist grip Do not use the assist grip when getting in or out of the vehicle or rising from your seat. Doing so could damage the assist grip, or could cause you to injure yourse ...

Reassembly
Caution: Wear protective gloves. Sharp areas on the seat frame (with adjuster) may injure your hands. Install front seat wire Install seat position airbag sensor (see page rs-390) Install lumbar support adjuster assembly Install the lumbar support adjuster with the 2 screws. ...

Shifting the shift lever
Vehicles without a smart key system While the engine switch is in the “on” position, move the shift lever with the brake pedal depressed. When shifting the shift lever between p and d, make sure that the vehicle is completely stopped. Vehicles with a smart key system While the en ...