Toyota RAV4 Service Manual: Data list / active test
- Read data list
Hint:
Using the intelligent tester's data list allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the data list early in troubleshooting is one way to save time.
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch on.
- Read the data list according to the display on the tester.
- Perform active test
Hint:
Performing the intelligent tester's active test allows relay, vsv, actuator and other items to be operated without removing any parts. Performing the active test early in troubleshooting is one way to save time.
The data list can be displayed during the active test.
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch on.
- Perform the active test by following the directions on the tester screen.
- Stop light switch circuit
- Headlight relay circuit
- Drl relay circuit
- Headlight (hi-beam) circuit
- Front fog light circuit
- Turn signal light circuit
- Hazard warning switch circuit
- Back-up light circuit
- Light control switch circuit
- Door courtesy switch circuit
- Door lock position circuit
- Footwell light circuit
- Illumination circuit
- Taillight relay circuit
Terminals of ecu
Check instrument panel junction block (main body ecu)
Measure the voltage of the connectors.
If the result is not as specified, the junction block
(main body ecu) may have ...
Stop light switch circuit
Description
When the stop light switch is turned on, current flows to the stop lights to
illuminate them.
Wiring diagram
Inspection procedure
Inspect fuse (stop)
Remove the stop fus ...
Other materials:
Auto lsd indicator light does not come on
Description
Refer to the description of "auto lsd indicator light remains on" (see page
bc-164).
Wiring diagram
Refer to the auto lsd indicator light circuit (see page bc-165).
Inspection procedure
Check can communication system
Check if the can communication system dtc is ...
Steering gear
Components
Removal
Position front wheels facing straight
ahead
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
...
Fuel pump control circuit
Description
When the engine is cranked, the starter relay drive signal output from the
star terminal of the ecm is
input into the sta terminal of the ecm, and ne signal generated by the
crankshaft position sensor is also
input into the ne+ terminal. Thus, the ecm interprets that the engine is ...
