Toyota RAV4 Service Manual: Data list / active test
- Read data list
Hint:
Using the intelligent tester's data list allows switch, actuator and other item values to be read without removing any parts. Reading the data list early in troubleshooting is one way to save time.
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch on.
- Read the data list.
Key reminder buzzer does not sound
Description
The key reminder warning buzzer sounds when the driver side door is opened while the ignition switch is in the lock or acc positions. The key reminder warning buzzer is activated when the main body ecu sends a key switch signal and driver side courtesy switch signal to the combination meter.
Hint: since the key reminder warning system has functions that use can communication, first confirm that there is no malfunction in the communication system by inspecting the can communication functions in accordance with the "how to proceed with troubleshooting" procedures. Then, conduct the following inspection procedure.
Wiring diagram
Inspection procedure
- Read value using intelligent tester (front door courtesy light switch)
- Check the data list to ensure proper operation of the front door courtesy light switch.
Ok: "on" (driver door is open) appears on the screen.
- Read value using intelligent tester (unlock warning switch)
- Check the data list to ensure proper operation of the door unlock warning switch.
Ok: "on" (key is in ignition key cylinder) appears on the screen.
- Inspect unlock warning switch assembly
- Remove the unlock warning switch.
- Measure the resistance of the switch.
Standard resistance 
- Check wire harness (unlock warning switch - main body ecu)
- Disconnect the e6 switch connector.
- Disconnect the ie junction block connector.
- Measure the resistance between the wire harness side connectors.
Standard resistance 
Replace instrument panel junction block (main body ecu)
- Inspect front door courtesy light switch (for driver side)
- Remove the courtesy light switch.
- Measure the resistance of the switch.
Standard resistance 
- Check wire harness and connectors (front door courtesy light switch - main body ecu)
- Disconnect the k7 connector.
- Disconnect the ia junction block connector.
- Measure the resistance between the wire harness side connectors.
Standard resistance 
Replace instrument panel junction block (main body ecu)
Diagnosis system
Description
Key reminder warning system data can be read
through the data link connector 3 (dlc3) of the
vehicle. When the system seems to be
malfunctioning, use the intelligent tes ...
Door control transmitter module
Components
Removal
Remove transmitter housing cover
Notice:
Take extra care when handling these precision
electronic components.
Twist the screwdriver in the direction of the arrow
...
Other materials:
Camshaft position sensor "a" circuit (bank 1 or single sensor)
Description
The camshaft position (cmp) sensor consists of a magnet and an iron core
which is wrapped with copper
wire, and is installed onto the cylinder head. When the camshaft rotates, each
of 3 teeth on the camshaft
passes through the cmp sensor. This activates the internal magnet in ...
Front console illumination
On-vehicle inspection
Inspect front console illumination
Connect the battery's positive (+) lead to terminal 1
and the negative (-) lead to terminal 2, then check
that the light comes on.
Ok:
light comes on.
If the result is not as specified, replace the front
console illumin ...
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms
are listed in order of probability in the "suspected area"
column of the table. Check each symptom by checking the
suspected areas in the order they are listed. Re ...
