Terms | Definition |
Monitor description | Description of what ecm monitors and how detects malfunctions (monitoring purpose and details). |
Related dtcs | Group of diagnostic trouble codes that are output by ecm based on same malfunction detection logic. |
Typical enabling condition | Preconditions that allow ecm to detect malfunctions.
With all preconditions satisfied, ecm sets dtc when monitored value(s) exceeds malfunction threshold(s). |
Sequence of operation | Order of monitor priority, applied if multiple sensors and
components involved in single
malfunction detection process.
Each sensor and component monitored in turn, when previous detection operation completed. |
Required sensor/components | Sensors and components used by ecm to detect each malfunction. |
Frequency of operation | Number of times ecm checks for each malfunction during each driving
cycle.
"Once per driving cycle" means ecm only performs checks for that malfunction once during single driving cycle. "Continuous" means ecm performs checks for that malfunction whenever enabling conditions met. |
Duration | Minimum time for which ecm must detect continuous deviation in monitored value(s) in order to set dtc. Timing begins when typical enabling conditions met. |
Malfunction thresholds | Value, beyond which, ecm determines malfunctions exist and sets dtcs. |
Mil operation | Timing of mil illumination after malfunction detected.
"Immediate" means ecm illuminates mil as soon as malfunction detected. "2 Driving cycle" means ecm illuminates mil if same malfunction detected second time during next sequential driving cycle. |
Vsc warning light does not come on
Description
Refer to the description of "vsc warning light remains on" (see page bc-139).
Wiring diagram
Refer to the vsc warning light circuit (see page bc-140).
Inspection procedure
Notice:
When replacing the abs and traction actuator, perform the zero point
calibration (see page ...
Check and replace ecu
Notice:
The connector should not be disconnected from
the ecu. Perform the inspection from the
backside of the connector on the wire harness
side.
When no measuring condition is specified,
perform the inspection with the engine stopped
and the ignition switch on.
Check that the con ...
Using the steering
wheel switches
The steering wheel switches can be used to operate a connected
cellular phone.
Operating a telephone using the steering wheel switches
Volume switch
Increase/decrease the volume
Press and hold:
continuously increase/
decrease the volume
Enter switch
Select an item
...