Toyota RAV4 (XA40) 2013-2018 Service Manual: Deterioration of battery
Description
The ecm determines the battery power according to the voltage of the batt terminal while the engine is running (not cranking).
Inspection procedure
- Inspect battery
- Inspect the battery specific gravity.
- Check the specific gravity of each cell.
Standard gravity: 1.25 To 1.29 At 20°c (68°f)
- Inspect the battery voltage.
- After the vehicle is driven for 20 minutes, stop the engine.
- Turn the ignition switch on, and turn on the headlights, blower fan and defogger for 1 minute.
- Turn the ignition switch off.
- Measure the battery voltage.
Standard voltage: 9.6 V or more
Battery current sensor circuit
Description
The battery current sensor installed on the positive (+) battery terminal
detects the amount of current
supplied from the generator.
The battery current sensor changes curre ...
Throttle actuator control motor circuit
Description
The throttle actuator is operated by the ecm and opens and closes the
throttle valve using gears.
The opening angle of the throttle valve is detected by the throttle position (tp ...
Other materials:
Oxygen (a/f) sensor heater control circuit
Hint:
Although the dtc titles say oxygen sensor, these dtcs relate to the
air-fuel ratio (a/f) sensor.
Sensor 1 refers to the sensor mounted in front of the three-way
catalytic converter (twc) and
located near the engine assembly.
Description
Refer to dtc p2195 (see page es-292 ...
Initializing the tire pressure
warning system (if
equipped)
â– The tire pressure warning
system must be initialized
in the following circumstances:
When rotating the tires.
When changing the tire.
After registering the ID codes.
When the tire pressure warning
system is initialized, the current
tire inflation pressure is set as
the benchmark pressure.
â ...
Vsc warning light does not come on
Description
Refer to the description of "vsc warning light remains on" (see page bc-139).
Wiring diagram
Refer to the vsc warning light circuit (see page bc-140).
Inspection procedure
Notice:
When replacing the abs and traction actuator, perform the zero point
calibration (see page ...
