The vehicle's ecm uses the iso 15765-4 for communication protocol. The terminal arrangement of the dlc3 complies with sae j1962 and matches the iso 15765-4 format.
If the result is not as specified, the dlc3 may have a malfunction. Repair or replace the harness and connector.
Notice:
*: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, other switches or doors.
Hint:
Connect the cable of the intelligent tester (with can vim) to the dlc3, turn the ignition switch on and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
If communication is normal when the tester is connected to another vehicle, inspect the dlc3 of the original vehicle.
If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the service department listed in the tester's instruction manual.
Trouble in passenger airbag on / off indicator
Description
The occupant classification system detects the front passenger seat condition
and then indicates whether
the front passenger airbag is activated or not through the passenger airbag on /
off indicator
illumination.
The passenger airbag on / off indicator illumination changes dep ...
Air fuel ratio sensor
Components
On-vehicle inspection
Check air fuel ratio compensation system
Connect the intelligent tester to the dlc3.
Turn the ignition switch on.
Select the following menu items: data list / a/fs b1
s1 and o2s b1 s2.
Warm up the a/f sensor with the engine speed at
2,500 ...
When servicing active torque control 4wd vehicles
The active torque control 4wd rav4 is equipped
with the 4 wheel drive control system.
If incorrect preparations or test procedures are
used, the test will not only be unsuccessful, but may
be dangerous as well.
Caution:
Never accelerate or decelerate the vehicle
suddenly.
Obs ...