Toyota RAV4 Service Manual: Diagnostic trouble code chart
Hint:
If any dtcs are displayed during the dtc check, inspect the circuit listed for these dtcs. For details of each dtc, refer to the page indicated in the dtc chart.
Hint:
: Warning
light comes on
X: warning light turns off (normal reset)
- Torque sensor
- Short in motor circuit
- Motor terminal voltage malfunction
- Motor rotation angle sensor malfunction
- Ecu malfunction
- Ig power supply voltage malfunction
- Pig power supply voltage malfunction
- Power supply relay failure
- Assist map number un-writing
- Control module communication bus off
- Eps warning light circuit
Data list / active test
Read data list
Hint:
Using the intelligent tester's data list allows switch,
sensor, actuator and other item values to be read without
removing any parts. Reading the data list early in
trou ...
Torque sensor
Description
The torque sensor converts the rotation torque input from the steering wheel
into electric signals and
sends them to the power steering ecu.
Wiring diagram
Inspection pro ...
Other materials:
Driving assist systems
To help enhance driving safety and performance, the following
systems operate automatically in response to various driving
situations. Be aware, however, that these systems are supplementary
and should not be relied upon too heavily when operating
the vehicle.
Abs (anti-lock brake system)
Help ...
Problem symptoms table (2005/11-2006/01)
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms
are listed in order of probability in the "suspected area"
column of the table. Check each symptom by checking the
suspected areas in the order they are listed. Re ...
Summary of the blind spot monitor
The blind spot monitor is a system that has 2 functions;
The blind spot monitor function
Assists the driver in making the decision when changing lanes
The rear cross traffic alert function
Assists the driver when backing up
These functions use same sensors.
Bsm main switch
...
