Look for output diagnostic trouble codes (dtcs) (from the dtc checks) in the appropriate section's diagnostic trouble code chart. Use the chart to determine the trouble area and the proper inspection procedure. A description of each of the chart's columns are below.
Item | Description |
Dtc no. | Indicates the diagnostic trouble code |
Detection item | Indicates the system or details of the problem |
Trouble area | Indicates the suspected areas of the problem |
See page | Indicates the page where the inspection procedures for each circuit are to be found, or gives instruction for checking and repairs |
Reassembly (2006/01- )
Install drive shaft bearing case subassembly
(for rh)
Install the bearing snap ring.
Using sst and a press, press in the drive shaft
bearing case to the inboard joint rh.
Sst 09527-10011, 09710-04081
Notice:
The bearing should be installed completely.
Using a snap rin ...
High beam automatic turning on or off conditions
When all of the following conditions are fulfilled, high beam will be
automatically turned on:
Vehicle speed is above approximately 21 mph (34 km/h).
The area ahead of the vehicle is dark.
There are no oncoming or preceding vehicles with headlights or tail
lights turned on.
There are fe ...
Initialization
Initialize sliding roof drive gear subassembly
Notice:
When replacing the sliding roof drive gear, the
sliding roof drive gear requires initialization. If a
reset is not executed, the following functions do not
operate: auto operation and key off operation.
Turn the ignition switch on. ...