Toyota RAV4 Service Manual: Diagnostic trouble code chart
If a dtc is displayed during the dtc check, check the circuit listed in the table below and proceed to the page given.
Hint:
- *1: "Comes on" means the malfunction indicator lamp (mil) illuminates.
- *2: "Dtc stored" means the ecm memorizes the malfunction code if the ecm detects the dtc detection condition.
- These dtcs may be output when the clutch, brake, gear components, etc., Inside the automatic transaxle are damaged.
- Transmission range sensor circuit malfunction (prndl input)
- Transmission fluid temperature sensor "A" circuit
- Transmission fluid temperature sensor "A" performance
- Input speed sensor circuit no signal
- Brake switch "B" circuit high
- Torque converter clutch solenoid performance (shift solenoid valve dsl)
- Pressure control solenoid "A " performance (shift solenoid valve sl1)
- Pressure control solenoid "A" electrical (shift solenoid valve sl1)
- Shift solenoid "d" performance (shift solenoid valve s4)
- Pressure control solenoid "B" performance (shift solenoid valve sl2)
- Pressure control solenoid "b" electrical (shift solenoid valve sl2)
- Intermediate shaft speed sensor "A"
- Shift solenoid "d" control circuit
- Pressure control solenoid "d" performance (shift solenoid valve slt)
- Pressure control solenoid "d" electrical (shift solenoid valve slt)
- Torque converter clutch solenoid circuit
Data list / active test
Read data list
Hint:
Using the intelligent tester's data list allows switch,
sensor, actuator, and other item values to be read
without removing any parts. Reading the data list
early in tro ...
Transmission range sensor circuit malfunction (prndl input)
Description
The park/neutral position (pnp) switch detects the shift lever position and
sends signals to the ecm.
Monitor description
These dtcs indicate a problem with the park/neutral p ...
Other materials:
Removal
(2005/11-2006/01)
Remove front wheel
Drain automatic transaxle fluid
Drain the automatic transaxle fluid for u140f (see
page ax-147).
Drain the automatic transaxle fluid for u241e (see
page ax-146).
Remove front axle hub nut (see page ah-6)
Disconnect front speed sensor lh (see page
bc-191) ...
Front console illumination
On-vehicle inspection
Inspect front console illumination
Connect the battery's positive (+) lead to terminal 1
and the negative (-) lead to terminal 2, then check
that the light comes on.
Ok:
light comes on.
If the result is not as specified, replace the front
console illumin ...
Fail-safe chart
Fail safe operation
If there is a problem with any sensor signals or
actuator systems, the skid control ecu prohibits the
power supply to the abs and traction actuator
and informs the ecm of vsc system failure.
The abs and traction actuator turns off the
solenoids and the ecm sh ...
