Toyota RAV4 (XA40) 2013-2018 Service Manual: Diagnostic trouble code chart (2005/11-2006/01)

Data list / active test (2006/01- )

Read data list Hint: Using the intelligent tester's data list allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the data list early in ...

Diagnostic trouble code chart (2006/01- )

Hint: When the air conditioning system functions properly, dtc b1400/00 is output. Hint: *1: Dtc b1422/22 (compressor lock sensor circuit) is indicated only for a currently occurring malfunct ...

Other materials:

Dtc check / clear
Check dtc (using sst (check wire)) Check the dtcs (present trouble code). Turn the ignition switch on, and wait for approximately 60 seconds. Using sst, connect terminals 13(tc) and 4(cg) of the dlc3. Sst 09843-18040 Notice: Connect the terminals to the correct positio ...

Inspection
Inspect generator brush holder assembly Using a vernier caliper, measure the brush length. Standard length: 9.5 To 11.5 Mm (0.374 To 0.453 In.) Minimum length: 4.5 Mm (0.177 In.) If the brush length is less than the minimum, replace the generator brush holder assembly. Inspe ...

Transmission wire
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove no. 1 Engine under cover Drain automati ...