Toyota RAV4 Service Manual: Diagnostic trouble code chart (2006/01- )
Hint:
When the air conditioning system functions properly, dtc b1400/00 is output.
Hint:
*1: Dtc b1422/22 (compressor lock sensor circuit) is indicated only for a currently occurring malfunction for 2grfe.
To confirm dtc b1422/22, perform the following steps:
- With the ignition switch on, enter the dtc check mode.
- Press the r/f (recirculation/fresh) switch to enter actuator check mode, and set the operation to step no. 3.
- Press the auto switch to return to dtc check mode.
- The dtc is displayed after approximately 3 seconds.
*2: Compressor and pulley for 2az-fe, compressor and magnetic clutch for 2gr-fe
- Room temperature sensor circuit
- Ambient temperature sensor circuit
- Evaporator temperature sensor circuit
- Solar sensor circuit (passenger side)
- Compressor lock sensor circuit
- Pressure sensor circuit
- Solar sensor circuit (driver side)
- Air mix damper control servo motor circuit (passenger side)
- Air inlet damper control servo motor circuit
- Air outlet damper control servo motor circuit
- Air mix damper control servo motor circuit (driver side)
- Compressor solenoid circuit (2005/11-2006/01)
- Compressor solenoid circuit (2006/01- )
- Bus ic communication malfunction
- Multiplex communication circuit
- Air conditioning control panel does not operate
- Blower motor circuit
- Compressor circuit
- Ig power source circuit
- Back-up power source circuit
Diagnostic trouble code chart (2005/11-2006/01)
Hint:
When the air conditioning system functions properly, dtc
b1400/00 is output.
...
Room temperature sensor circuit
Description
The room temperature sensor is installed in the instrument panel to detect
the room temperature and
control the heater and air conditioner auto mode. The resistance of the room
t ...
Other materials:
Installation (2006/01- )
Install front drive shaft assembly lh
Coat the spline of the inboard joint shaft with gear
oil.
Align the shaft splines and tap in the drive shaft with
a brass bar and hammer.
Notice:
Set the snap ring with the opening side facing
downwards.
Be careful not to damage the ...
Transmission control cable assembly
Replacement
Remove rear console box sub-assembly
Remove the console box (see page ip-20).
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pre ...
Tire pressure warning light circuit
Description
If the tire pressure warning ecu detects trouble, the tire pressure warning
light turns on and tire pressure
monitor is canceled at the same time. At this time, the ecu records a dtc in
memory.
Connect terminals tc and cg of the dlc3 to make the tire pressure warning light
bli ...
