Toyota RAV4 Service Manual: Differential oil
On-vehicle inspection
- Check differential oil
- Stop the vehicle on a level surface.
- Using a 10 mm socket hexagon wrench, remove the rear differential filler plug and gasket.
- Check that the oil level is between 0 to 5 mm (0 to 0.20 In.) From the bottom lip of the differential filler plug hole.
Notice:
- After changing the oil seal, drive the vehicle and then check the oil level again.
- Too much or too little oil will lead to differential problems.
Hint:
If necessary, fill the differential carrier assembly with hypoid gear oil.
Recommended viscosity: sae 90
Standard oil grade: hypoid gear oil sx api gl-5
Standard differential oil capacity: 0.45 To 0.55 Liters (0.48 To 0.58 Us qts., 0.40 To 0.48 Imp. Qts.)
- Using a 10 mm socket hexagon wrench, install a
new gasket and the rear differential filler plug.
Torque: 39 n*m (398 kgf*cm, 29 ft.*Lbf)
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in order of probability in the "suspected area" column of
th ...
Rear differential side gear shaft oil seal
Components
Removal
Drain differential oil (see page df-10)
Remove tailpipe assembly
Remove the tailpipe (see page ex-2).
Remove center exhaust assembly
Remove propelle ...
Other materials:
Ecm power source circuit
Description
When the ignition switch is turned on, the battery voltage is applied to the
igsw of the ecm. The output
signal from the mrel terminal of the ecm causes a current to flow to the coil,
closing the contacts of the
integration relay (efi main relay) and supplying power to either term ...
Outer rear view mirror
Components
Removal
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
Remove front door lower frame bracket
garnish lh (see page ed-19)
Remove front armrest upper base panel
lh (see page ed-19)
Remove front door t ...
Dtc check / clear
Check dtc
Connect the intelligent tester to the dlc3.
Turn the ignition switch on and turn the tester on.
Select the following menu item: body / sliding roof /
dtc.
Check the dtc(s).
Clear dtc
Connect the intelligent tester to the dlc3.
Turn the ignition switch on ...
