Toyota RAV4 (XA40) 2013-2018 Service Manual: Differential system

Differential

...

Precaution

Before disassembling the differential assembly, thoroughly clean it by removing any sand, mud or foreign matter. This will help prevent contamination during disassembly and reassembly. When ...

Other materials:

Reassembly (2006/01- )
Install front drive shaft bearing (for rh) Install the bearing bracket snap ring to the inboard shaft. Using sst and a press, press in the drive shaft bearing to the inboard joint rh. Sst 09527-10011, 09710-04081 Notice: The bearing should be installed completely. Usi ...

Reassembly
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Install seat lock release band Install the band with nut. Hint: After installing the band, feed it through the seatback frame hole towards the rear of the vehicle. I ...

Taillight relay circuit
Description When the light control switch, located on the headlight dimmer switch, is turned to the tail position, the taillight relay (marking: t-lp) turns on to illuminate the front side marker lights, rear taillights, side marker lights and license plate light. Wiring diagram Ins ...