Toyota RAV4 manuals

Toyota RAV4 Service Manual: Disassembly

  1. Remove radio setting condenser

Toyota RAV4. Remove radio setting condenser


  1. Remove the bolt and condenser.
  1. Remove oil pressure switch

Toyota RAV4. Remove oil pressure switch


  1. Using a 24 mm deep socket wrench, remove the sensor.
  1. Remove engine coolant temperature sensor

Toyota RAV4. Remove engine coolant temperature sensor


  1. Using sst, remove the sensor and gasket.

Sst 09817-33190

  1. Remove camshaft position sensor

Toyota RAV4. Remove camshaft position sensor


  1. remove the bolt and sensor.
  1. Remove no. 2 Camshaft bearing

Toyota RAV4. Remove no. 2 Camshaft bearing


  1. Remove the no. 2 Camshaft bearing.
  1. Remove no. 1 Camshaft bearing

  1. Remove the no. 1 Camshaft bearing.
  1. Remove valve lifter

Toyota RAV4. Emove valve lifter


Hint:

Arrange the valve lifters in the correct order.

  1. Remove intake valve

Toyota RAV4. Remove intake valve


  1. Place the cylinder head on wooden blocks.
  2. Using sst, compress the spring, then remove the 2 retainer locks.

Sst 09202-70020 (09202-00010)

Toyota RAV4. Remove intake valve


  1. Remove the retainer, spring and valve from the cylinder head.

Hint:

Arrange the removed parts in the correct order.

  1. Remove exhaust valve

  1. Place the cylinder head on wooden blocks.
  2. Using sst, compress the spring, then remove the 2 retainer locks.

Sst 09202-70020 (09202-00010)

Toyota RAV4. Remove exhaust valve


Toyota RAV4. Remove exhaust valve


  1. Remove valve spring seat

  1. Using compressed air and a magnetic finger, remove the spring seat by blowing air.

Hint:

Arrange the valves, valve springs, spring seats and spring retainers in the correct order.

Toyota RAV4. Remove valve spring seat


  1. Remove valve stem oil seal


  1. Using needle-nose pliers, remove the 16 oil seals.
Removal
Discharge fuel system pressure (see page fu-9) Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) batte ...

Inspection
Inspect cylinder head for warpage Using a precision straightedge and feeler gauge, measure the warpage of the contact surfaces of the cylinder block and manifolds. Maximum warpage: ...

Other materials:

Mechanical system tests
Stall speed test Hint: This test is to check the overall performance of the engine and transaxle. Notice: Do not perform the stall speed test longer than 5 seconds. To ensure safety, perform this test in an open and level area that provides good traction. The stall speed test sh ...

Registration
Hint: The key has 2 codes: the key code (immobiliser code) and the wireless code (recognition code). Both of these codes need to be registered. For wireless code registration procedures, refer to the following procedures (see page dl- 46). For key code registration procedures, refer to the pro ...

Front wiper motor
Inspection Inspect front wiper motor Check the lo operation. Connect the battery's positive (+) lead to terminal 5 (+1) and the negative (-) lead to terminal 4 (e), and check that the front wiper motor operates at low speed (lo). Ok: front wiper motor operates at low sp ...

В© 2011-2024 Copyright www.trav4.net