Toyota RAV4 (XA40) 2013-2018 Service Manual: Disassembly
- Remove magnetic switch assembly
- Remove the nut and disconnect the lead wire from the magnetic switch.
- Remove the 2 screws holding the magnetic switch to the starter drive housing.
- Remove the magnetic switch.
- Remove the return spring and plunger from the starter drive housing.
- Remove starter yoke assembly
- Remove the 2 through-bolts, and pull out the starter yoke together with the commutator end frame.
- Remove the starter yoke from the commutator end frame.
- Remove starter armature plate
- Remove the armature plate from the starter yoke.
- Remove starter commutator end frame cover
- Using a screwdriver, pry out the commutator end frame cover.
- Remove starter armature assembly
- Using snap ring pliers, remove the snap ring and plate washer.
- Remove the armature from the commutator end frame.
- Remove planetary gear
- Remove the 3 planetary gears from the starter drive housing.
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt preten ...
Inspection
Inspect starter assembly
Notice:
These tests must be performed within 3 to 5 seconds
to avoid burning out the coil.
Perform the pull-in test.
Disconnect the lead wire from terminal c ...
Other materials:
Console box
Lift the lid while pulling up the
lever to release the lock.
When using the console box lid as an armrest (vehicles with slide
function)
Slide the console box lid forward as
needed. Pull the lid forward by holding the
front of the lid.
Caution
Console box adjustment precaution
D ...
Removal (2005/11-2006/01)
Remove front wheel
Drain automatic transaxle fluid
Drain the automatic transaxle fluid for u140f (see
page ax-147).
Drain the automatic transaxle fluid for u241e (see
page ax-146).
Remove front axle hub nut (see page ah-6)
Disconnect front speed sensor lh
Disconnect th ...
Disassembly
Remove park/neutral position switch assembly
Remove the nut, washer and control shaft lever.
Using a screwdriver, pry off the lock plate.
Remove the nut and lock plate.
Remove the 2 bolts and pull out the switch.
Remove breather plug hose
Remove oil coo ...
