Toyota RAV4 Service Manual: Disassembly
- Remove generator pulley with clutch
- Remove the cap from the pulley.
- Using a screwdriver, puncture the center of the cap and pry it off.
Notice:
Do not reuse the cap.
- Install sst to the pulley and vise as shown in the illustration.
Sst 09820-63020
- Mount sst (a) in a vise.
- Turn sst (b) clockwise to loosen the pulley.
- Remove the pulley.
- Remove generator brush holder assembly
- Remove the 3 nuts and generator rear end cover.
- Remove the terminal insulator.
- Remove the 2 screws and generator brush holder.
- Remove generator rotor assembly
- Remove the bolt and cord clip.
- Remove the 4 bolts.
- Using sst, remove the coil.
Sst 09950-40011 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010)
- Remove the washer.
- Remove the generator rotor.
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt preten ...
Inspection
Inspect generator brush holder assembly
Using a vernier caliper, measure the brush length.
Standard length:
9.5 To 11.5 Mm (0.374 To 0.453 In.)
Minimum length:
4.5 Mm (0.177 In.)
If th ...
Other materials:
Parts location
System diagram
Hint:
The abs and traction actuator (skid control ecu)
detects and stores steering sensor and yaw rate
sensor dtcs and performs dtc communication by
receiving information from the steering sensor and
yaw rate sensor.
The ecm uses the can communication sy ...
Front occupant classification sensor lh collision detection
Description
Dtc b1785 is output when the occupant classification ecu receives a collision
detection signal sent by
the front occupant classification sensor lh when an accident occurs.
Dtc b1785 is also output when the front seat rh is subjected to a strong impact,
even if an actual
acc ...
Releasing and stowing the seat belt (for the rear center seat)
To release the hooked buckle
“b”, push the buckle release
button.
Release button
To release the hooked plate
A insert the mechanical key
Or plate B or the
wireless key into the hole on
the buckle.
When releasing the seat belt,
retract it slowly.
Stow th ...
