Toyota RAV4 Service Manual: Disassembly
- Remove no. 1 Side defroster nozzle duct
- Remove the 3 screws and duct.
- Remove no. 2 Side defroster nozzle duct
- Remove the 3 screws and duct.
- Remove no. 1 Heater to register duct
- Remove the screw and duct.
- Remove no. 2 Heater to register duct
- Remove the screw and duct.
- Remove no. 3 Heater to register duct
- Remove the 2 screws and duct.
- Remove no. 1 Instrument panel register assembly
- Remove no. 2 Instrument panel register assembly
- Remove front passenger airbag assembly (see page rs-350)
- Remove automatic light control sensor (for automatic light control system)
- Remove cooler (solar sensor) thermistor (for automatic air conditioning system)
Removal
Table of bolt, screw and nut
Hint:
All bolts, screws and nuts relevant to installing and
removing the instrument panel are shown along with
their alphabet codes in the table below.
Di ...
Reassembly
Install cooler (solar sensor) thermistor
(for automatic air conditioning system)
Install automatic light control sensor
(for automatic light control system)
Install front passenger airbag a ...
Other materials:
Diagnostic trouble code chart
Hint:
If no abnormality is found when inspecting parts, check the
skid control ecu and check for poor contact at the ground
points.
If a dtc is displayed during the dtc check, check the
circuit for the dtc listed in the table below. For details of
each dtc, refer to the page indicated. ...
Rear occupant classification sensor rh circuit malfunction
Description
The rear occupant classification sensor rh circuit consists of the occupant
classification ecu and the
rear occupant classification sensor rh.
Dtc b1783 is recorded when a malfunction is detected in the rear occupant
classification sensor rh
circuit.
Wiring diagram
...
Memory recall function (vehicles with a smart key system)
Each electronic key can be registered to recall your preferred driving
position.
Registering procedure
Record your driving position to button “1” or “2” before performing
the following:
carry only the key you want to register, and then close the driver’s
door.
If 2 or more keys ar ...
