Toyota RAV4 (XA40) 2013-2018 Owners Manual: Displaying a bluetooth® device details
You can confirm and change the registered device details.
Bluetooth® device registration status
- Display the “bluetooth* setup” screen.
*: Bluetooth is a registered trademark of bluetooth sig, inc.
- Select the device.
- Select “device info”.
- Following screen is displayed:
- Device name
- Change connection method
- Bluetooth® address
- Display your telephone number
The number may not be displayed depending on the model of phone.
- Compatibility profile of the device
- Restore default settings
Changing connection method
- Select “connect audio player from”.
- Select “vehicle” or “device”.
“Vehicle”: connect the audio system to the portable audio player.
“Device”: connect the portable audio player to the audio system
Connecting a bluetooth®
device
Up to 5 bluetooth® devices (phones (hfp) and audio players
(avp)) can be registered.
If more than 1 bluetooth® device has been registered, select
which device to connect to.
Press the “se ...
Detailed bluetooth®
system settings
You can confirm and change the detailed bluetooth® settings.
How to check and change detailed bluetooth® settings
Display the “bluetooth* setup” screen.
Select “system settings”.
Th ...
Other materials:
Open in stop light switch circuit
Description
The skid control ecu detects the brake operating conditions through a signal
transmitted by the stop light
switch. The skid control ecu incorporates an open circuit detection circuit.
This dtc is set under either of
the following conditions:
An open is detected in the stop lig ...
Installation
Install engine coolant temperature
sensor
Install a new gasket onto the sensor.
Using sst, install the sensor.
Sst 09817-33190
torque: 19.6 N*m (200 kgf*cm, 14 ft.*Lbf)
Connect the sensor connector.
Install air cleaner case (see page es-431)
Install air cleaner cap ( ...
Moon roof
Use the overhead switches
to open and close the moon
roof and tilt it up and down.
Operating the moon roof
■ Opening and closing
Opens the moon roof*
The moon roof stops slightly before
the fully open position to reduce
wind noise.
Press the switch again to fully open
the moon roof.
Close ...
