Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Owners Manual: Do-it-yourself service precautions

If you perform maintenance by yourself, be sure to follow the correct procedure as given in these sections.

Toyota RAV4. Do-it-yourself service precautions


Toyota RAV4. Do-it-yourself service precautions


Toyota RAV4. Do-it-yourself service precautions


Caution

The engine compartment contains many mechanisms and fluids that may move suddenly, become hot, or become electrically energized. To avoid death or serious injury, observe the following precautions.

When working on the engine compartment

Caution

When working near the electric cooling fans or radiator grille

Vehicles without a smart key system

Be sure the engine switch is off. With the engine switch in the “on” position, the electric cooling fans may automatically start to run if the air conditioning is on and/or the coolant temperature is high.

Vehicles with a smart key system

Be sure the engine switch is off. With the engine switch in ignition on mode, the electric cooling fans may automatically start to run if the air conditioning is on and/or the coolant temperature is high

Safety glasses

Wear safety glasses to prevent flying or falling material, fluid spray, etc.

From getting in your eyes.

Notice

If you remove the air cleaner filter

Driving with the air cleaner filter removed may cause excessive engine wear due to dirt in the air.

Do-it-yourself maintenance
...

Hood
Release the lock from the inside of the vehicle to open the hood Pull the hood lock release lever. The hood will pop up slightly. Push the auxiliary catch lever to the left and lift t ...

Other materials:

Headlight assembly
Components Removal Hint: Use the same procedures for the rh and lh sides. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Remove front fender liner lh (see page et-4) Remove front fender liner rh (see page et-4) Remove ra ...

Blower motor circuit
Description When the heater control (blower switch) is set to position 1 or higher, the contact of the htr relay is closed, current flows to the blower motor, and the blower motor operates. The blower motor speed can be changed by exchanging the ground and the blower resistor circuit with the ...

No signal from transmitter id
Description The tire pressure warning valve and transmitter constantly sends radio waves to the tire pressure warning ecu. Under the following conditions, the tire pressure warning antenna and receiver is unable to receive the signals from the tire pressure warning valve and transmitte ...

© 2011-2024 Copyright www.trav4.net