Toyota RAV4 (XA40) 2013-2018 Service Manual: Door control switch
Inspection
- Inspect power window regulator master switch assembly (door control switch)
- Measure the resistance of the door control switch.
Standard resistance 
If the result is not as specified, replace the power window regulator master switch assembly.
- Inspect door control switch assembly
- Measure the resistance of the door control switch.
Standard resistance 
If the result is not as specified, replace the door control switch assembly.
Door control transmitter module
Components
Removal
Remove transmitter housing cover
Notice:
Take extra care when handling these precision
electronic components.
Twist the screwdriver in the direction of the arrow
...
Front door lock
Inspection
Inspect front door with motor lock assembly lh
Apply the battery voltage to the motor terminals and
check the operation of the door lock motor.
Ok
If the result is not ...
Other materials:
Rear center seat outer belt assembly
Components
Removal
Caution:
Wait at least 90 seconds after disconnecting the cable
from the negative (-) battery terminal to prevent airbag
and seat belt pretensioner activation.
Remove shoulder belt anchor cover rh
Using a screwdriver, remo ...
Compressor solenoid circuit (2006/01- )
Description
In this circuit, the compressor receives a refrigerant compression demand
signal from the air conditioning
amplifier. Based on this signal, the compressor changes the degree of
refrigerant compression.
Hint:
*: Compressor and pulley for 2az-fe, compressor and magnetic clu ...
Front passenger side - side airbag sensor circuit malfunction
Description
The side airbag sensor rh consists of parts including the diagnostic circuit
and the lateral deceleration
sensor.
When the center airbag sensor receives signals from the lateral deceleration
sensor, it determines
whether or not the srs should be activated.
Dtc b1625/22 i ...
