Toyota RAV4 Service Manual: Door lock position circuit
Description
This circuit detects the state of the door lock detection sensor and sends it to the main body ecu.
Wiring diagram
Inspection procedure
- Read value of intelligent tester (door lock position)
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch to the on position and press the intelligent tester main switch on.
- Select the items below in the data list, and read the displays on the intelligent tester.
Ok: condition sign can be displayed.
- Inspect front door lock
- Remove the front door lock (driver side or passenger side).
- Measure the resistance of the door lock.
Standard resistance:
front door lock (for driver side) 
Front door lock (for passenger side)
- Check wire harness (main body ecu - door lock and body ground)
- Disconnect the e15 main body ecu connector.
- Measure the resistance of the wire harness side connector.
Standard resistance:
front door lock (for driver side) 
Front door lock (for passenger side)
Replace instrument panel junction block (main body ecu)
Door courtesy switch circuit
Description
The main body ecu detects the condition of the door courtesy switch.
Wiring diagram
Inspection procedure
Read value of intelligent tester (door courtesy light switch)
Conn ...
Footwell light circuit
Description
The main body ecu receives information regarding the door lock position
switch and ignition switch, and
turns on each foot light.
Wiring diagram
Inspection procedure
Perform ...
Other materials:
Disassembly (2005/11-2006/01)
Remove front axle inboard joint boot no. 2 Clamp lh
One touch type:
Using a screwdriver, remove the inboard joint
boot clamp, as shown in the illustration.
Claw engagement type:
Using needle-nose pliers, remove the inboard
joint boot clamp, as shown in the illustra ...
Pressure control solenoid "d" performance (shift solenoid valve slt)
Description
The throttle pressure that is applied to the primary regulator valve (which
modulates the line pressure)
causes the solenoid valve slt, under electronic control, to precisely modulate
and generate the line
pressure according to the extent that the accelerator pedal is depr ...
Parts location
System diagram
Hint:
The abs and traction actuator (skid control ecu)
detects and stores steering sensor and yaw rate
sensor dtcs and performs dtc communication by
receiving information from the steering sensor and
yaw rate sensor.
The ecm uses the can communication sy ...
