Components
Removal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Inspection
Standard resistance
If the result is not as specified, replace the switch.
(1) Connect the battery's positive (+) lead to terminal 3 and negative (-) lead to terminal 2.
Then check that the bulb illuminates.
Ok: bulb illuminates.
If the result is not as specified, replace the switch.
Installation
Driver side seat belt warning light does not operate
Description
When the ignition switch is on, the center airbag sensor transmits front seat
inner belt status signals to
the combination meter through the can bus line. If the driver seat belt is not
fastened, the combination
meter blinks the driver side seat belt warning light. If the seat bel ...
Connecting a bluetooth®
device
Up to 5 bluetooth® devices (phones (hfp) and audio players
(avp)) can be registered.
If more than 1 bluetooth® device has been registered, select
which device to connect to.
Press the “setup” button.
Select “bluetooth*”.
*: Bluetooth is a registered trademark of bluetooth sig ...
Inner rear view mirror
Components
Removal
Remove inner rear view mirror assembly
Disengage the 2 claws and separate the inner rear
view mirror cover as shown in the illustration.
Remove the inner rear view mirror as shown in the
illustration.
Installation
Install inner rear view mir ...