Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Drive shaft

Installation
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Install rear stabilizer bush Install the 2 bushes. Hint: Instal ...

Drive shaft system
...

Other materials:

Electronic control
Removal and installation of battery terminal Notice: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal. Before performing electronic work, disconnect the cable from the negative (-) battery terminal to ...

Air conditioning filter
The air conditioning filter must be changed regularly to maintain air conditioning efficiency. Removal method 1. Turn the engine switch to OFF. 2. Open the glove box and slide off the damper. 3. Push in each side of the glove box to disconnect the claws, and then slowly and fully open the glove bo ...

On-vehicle inspection
Inspect refrigerant pressure with manifold gauge set This method uses a manifold gauge set to locate problem areas. Read the manifold gauge pressure when these conditions are established. Test conditions: Temperature at the air inlet is 30 to 35°c (86 to 95°f). Engine is ...

© 2011-2026 Copyright www.trav4.net