Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Owners Manual: Driving position memory

This feature automatically adjusts the driver’s seat to suit your preferences.

Rear seats
Adjustment procedure Pull up the lever. Then lean back to the desired angle and release the lever. When a person sits in the rear center position, align all seatbacks at the same angle. Foldi ...

Driving position memory
Your preferred driving position (the position of the driver’s seat) can be recorded and recalled by pressing a button. Two different driving positions can be recorded into memory. Recording pro ...

Other materials:

Dtc check / clear
Check dtc (using sst (check wire)) Check the dtcs (present trouble code). Turn the ignition switch on, and wait for approximately 60 seconds. Using sst, connect terminals 13(tc) and 4(cg) of the dlc3. Sst 09843-18040 Notice: Connect the terminals to the correct positio ...

Compressor solenoid circuit (2006/01- )
Description In this circuit, the compressor receives a refrigerant compression demand signal from the air conditioning amplifier. Based on this signal, the compressor changes the degree of refrigerant compression. Hint: *: Compressor and pulley for 2az-fe, compressor and magnetic clu ...

Installation (2006/01- )
Install front drive shaft assembly lh Coat the spline of the inboard joint shaft with gear oil. Align the shaft splines and tap in the drive shaft with a brass bar and hammer. Notice: Set the snap ring with the opening side facing downwards. Be careful not to damage the ...

© 2011-2026 Copyright www.trav4.net