Toyota RAV4 (XA40) 2013-2018 Owners Manual: Driving procedures
- Engine (ignition) switch (vehicles without a smart key system)
- Engine (ignition) switch (vehicles with a smart key system)
- Automatic transmission
- Turn signal lever
- Parking brake
- Horn
Dinghy towing
Your vehicle is not designed to be dinghy towed (with 4 wheels
on the ground) behind a motor home.
Notice
To avoid serious damage to your vehicle
Do not tow your vehicle with 4 wheels on
the grou ...
Engine (ignition) switch
(vehicles without a
smart key system)
Starting the engine
Check that the parking brake is set.
Check that the shift lever is set in p.
Firmly depress the brake pedal.
Turn the engine switch to the “start” position to start t ...
Other materials:
Disassembly
Remove radio setting condenser
Remove the bolt and condenser.
Remove oil pressure switch
Using a 24 mm deep socket wrench, remove the sensor.
Remove engine coolant temperature sensor
Using sst, remove the sensor and gasket.
Sst 09817-33190
Remove c ...
Reassembly
Install wiring harness clamp bracket
Install the bracket with the bolt.
Install elbow tube
Install straight pin
Using a plastic hammer, install the 4 straight pins to
the rear differential carrier.
Thoroughly clean oil and water from the surface of
the rear different ...
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove front seat track bracket outer
cover lh (see page se-11)
Remove fr ...
