Toyota RAV4 (XA40) 2013-2018 Service Manual: Dtc check / clear
- Check dtc
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch on and turn the intelligent tester on.
- Select the following menu items: diagnosis / obd/mobd / immobiliser / dtc info / current codes.
- Check dtcs and then write them down.
Hint:
Refer to the intelligent tester operator's manual for further details.
- Confirm the details of the dtcs (see page ei-20).
- Clear dtc
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch on (do not start the engine) and turn the intelligent tester on.
- Select the following menu items: diagnosis / obd/mobd / immobiliser / dtc info / clear codes.
Hint:
Refer to the intelligent tester operator's manual for further details.
- Erase dtcs by pressing the yes button on the tester.
Hint:
Refer to the intelligent tester operator's manual for further details.
Diagnosis system
Description
Engine immobiliser system data and diagnostic
trouble codes (dtcs) can be read through the
vehicle's data link connector 3 (dlc3). In some
cases, a malfunction may be occurr ...
Data list / active test
Read data list
Hint:
Using the intelligent tester's data list allows switch,
sensor, actuator and other item values to be read without
removing any parts. Reading the data list early in
trou ...
Other materials:
The rear cross traffic alert function
The rear cross traffic alert functions when your vehicle is in reverse.
It can detect other vehicles approaching from the right or left rear of
the vehicle. It uses radar sensors to alert the driver of the other vehicle’s
existence through flashing the outside rear view mirror indicators
and ...
Fuel pressure pulsation damper
Components
Removal
Discharge fuel system pressure (see page
fu-9)
Disconnect cable from negative battery
terminal
Remove no. 1 Engine cover (see page es-410)
Remove air cleaner cap sub-assembly (see
page es-411)
Disconnect fuel main tube (see page fu-10)
Remove fuel pres ...
Short in driver side squib 2nd step circuit
Description
The driver side squib 2nd step circuit consists of the center airbag sensor,
the spiral cable and the
steering pad.
The circuit instructs the srs to deploy when the deployment conditions are met.
These dtcs are recorded when a malfunction is detected in the driver side squi ...
