Toyota RAV4 Service Manual: Dtc check / clear
- Check dtc (when using intelligent tester)
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch on.
- Turn the tester on.
- Read the dtcs by following the prompts on the tester screen.
Hint:
Refer to the intelligent tester operator's manual for further details.
- Clear dtc (when using intelligent tester)
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch on.
- Turn the tester on.
- Operate the intelligent tester to clear the codes.
Hint:
Refer to the intelligent tester operator's manual for further details.
- Check dtc (when not using intelligent tester)
- Using sst, connect terminals 13 (tc) and 4 (cg) of the dlc3.
Sst 09843-18040
- Turn the ignition switch on.
- Read dtcs from the abs warning light on the combination meter.
Hint:
- If the abs warning light does not blink, perform
relevant troubleshooting procedures. The
relevant troubleshooting procedures are in the
sections listed in the table below.
- As an example, the blinking patterns of the normal system code and dtcs 11 and 21 are shown below.
- Dtcs are explained in the "diagnostic trouble code chart" (see page bc-57).
- After completing the check, disconnect sst from terminals 13 (tc) and 4 (cg) of the dlc3, and turn the ignition switch off.
Hint:
- If 2 or more malfunctions are detected at the same time, the lowest numbered dtc is displayed first.
- Clear dtc (when not using intelligent tester)
- Using sst, connect terminals 13 (tc) and 4 (cg) of the dlc3.
Sst 09843-18040
- Turn the ignition switch on.
- Clear the dtcs stored in the skid control ecu by depressing the brake pedal 8 times or more within 5 seconds.
- Check that the abs and vsc warning lights come on.
- Remove sst from the terminals of the dlc3.
- Turn the ignition switch off.
Hint:
Clearing the dtcs cannot be performed by removing the cable from the negative (-) battery terminal or the ecu-ig1 fuse.
- End of dtc check/clear
- Turn the ignition switch on.
- Check that the abs and vsc warning lights go off within approximately 3 seconds.
- Turn the ignition switch off.
Diagnosis system
Diagnosis
If the skid control ecu detects a malfunction, the abs,
vsc and brake warning lights and the slip, downhill
assist control and auto lsd indicator lights come on in
accordance with t ...
Freeze frame data
Freeze frame data
Hint:
Whenever a dtc is detected or the abs operates,
the skid control ecu stores the current vehicle
(sensor) state as freeze frame data.
The skid control ecu stores ...
Other materials:
Reassembly
Install cooler (solar sensor) thermistor
(for automatic air conditioning system)
Install automatic light control sensor
(for automatic light control system)
Install front passenger airbag assembly
(see page rs-351)
Install no. 2 Instrument panel register
assembly
Install no. 1 Ins ...
How to proceed with troubleshooting (2006/01- )
Hint:
Use these procedures to troubleshoot the air conditioning
system
*: Use the intelligent tester.
Vehicle brought to workshop
Customer problem analysis and symptom check
Inspect battery voltage
Standard voltage:
11 to 14 v
If the voltage is below 11 v, rechar ...
Master cylinder pressure sensor malfunction
Description
The master cylinder pressure sensor is connected to the skid control ecu in
the abs and traction
actuator.
Dtc c1281/81 can be detected when the master cylinder pressure sensor sends a
master cylinder
pressure signal or test mode ends. Dtc c1281/81 is output only in test mo ...
