Toyota RAV4 manuals

Toyota RAV4 Service Manual: Ecm communication stop mode (2006/01- )

Toyota RAV4 Service Manual / Can communication / Fail-safe chart / Ecm communication stop mode (2006/01- )

Description

Toyota RAV4. Ecm communication stop mode (2006/01- )


Wiring diagram

Toyota RAV4. Ecm communication stop mode (2006/01- )


Toyota RAV4. Ecm communication stop mode (2006/01- )


Inspection procedure

Notice:

Hint:

Operating the ignition switch, any switches or any doors triggers related ecu and sensor communication with the can, which causes resistance variation.

  1. Check wire harness (ecm - battery and body ground)

  1. Disconnect the a9 and b30 ecm connectors.

Toyota RAV4. Check wire harness (ecm - battery and body ground)


  1. Measure the resistance of the wire harness side connector.

Standard resistance: for 2az-fe


For 2gr-fe


  1. Measure the voltage of the wire harness side connector.

Standard voltage




Replace ecm

Ecm communication stop mode (2005/11-2006/01)
Description Wiring diagram Inspection procedure Notice: Turn the ignition switch off before measuring the resistances of the main wire and the branch wire. After the ignition swi ...

Main body ecu communication stop mode
Description Wiring diagram Inspection procedure Notice: Turn the ignition switch off before measuring the resistances of the main wire and the branch wire. After the ignition sw ...

Other materials:

Wireless remote control/electronic key battery
Replace the battery with a new one if it is depleted. You will need the following items: Flathead screwdriver Small flathead screwdriver Lithium battery cr2016 (vehicles without a smart key system), or cr2032 (vehicles with a smart key system) Replacing the battery Vehicles without a ...

Automatic transaxle fluid
On-vehicle inspection Check transaxle fluid level Hint: Drive the vehicle so that the engine and transaxle are at normal operating temperature. Fluid temperature: 70 to 80°c (158 to 176°f) Park the vehicle on a level surface and set the parking brake. With the engine idling and ...

Can communication system
Precaution Precaution Turn the ignition switch off before measuring the resistance of the main wire and the branch wire. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation. Before measuring th ...

© 2011-2024 Copyright www.trav4.net