Some states have vehicle emission inspection programs which include obd (on board diagnostics) checks. The obd system monitors the operation of the emission control system.
If the malfunction indicator lamp comes on
The obd system determines that a problem exists somewhere in the emission control system. Your vehicle may not pass the i/m test and may need to be repaired. Contact your toyota dealer to service the vehicle.
Your vehicle may not pass the i/m test in the following situations:
Readiness codes that are set during ordinary driving are erased.
Also, depending on your driving habits, the readiness codes may not be completely set.
The malfunction indicator lamp comes on indicating a temporary malfunction and your vehicle may not pass the i/m test.
When the malfunction indicator lamp still remains on after several driving trips
The error code in the obd system will not be cleared unless the vehicle is driven 40 or more times.
If your vehicle does not pass the i/m test
Contact your toyota dealer to prepare the vehicle for re-testing.
Disassembly (2005/11-2006/01)
Remove front axle inboard joint boot no. 2 Clamp lh
One touch type:
Using a screwdriver, remove the inboard joint
boot clamp, as shown in the illustration.
Claw engagement type:
Using needle-nose pliers, remove the inboard
joint boot clamp, as shown in the illustra ...
Problem symptoms table (2006/01- )
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in order of probability in the "suspected area" column
of the table. Check each symptom by checking the suspected
areas in the order they are listed. Replace p ...
Vehicle lift and support locations
Notice about vehicle condition when
jacking up vehicle
The vehicle must be unloaded before jacking up /
lifting up the vehicle. Never jack up / lift up a heavily
loaded vehicle.
When removing heavy parts such as the engine and
transmission, the center of gravity of the vehicle
m ...