Description
If a malfunction in the engine control system is detected, the operations of vsc and trc are prohibited by the fail-safe function. When the signals from the engine are input normally, the fail-safe is canceled and the dtc is not stored.
Inspection procedure
Ok: there are no momentary interruptions.
Hint:
Perform the above inspection before removing the sensor and connector.
Result
Repair engine control system
Result
End
Body
General maintenance
Tighten bolts and nuts
Tighten the bolts and nuts on the chassis parts listed
below, if necessary.
Front axle and suspension
Drivetrain
Rear axle and suspension
Brake system
Engine mounting
Other chassis parts
Tighten the bolts and nuts on the bo ...
Parts location
System diagram
...
Data list / active test
Read data list
Hint:
Using the intelligent tester's data list allows switch,
sensor, actuator and other item values to be read without
removing any parts. Reading the data list early in
troubleshooting is one way to save time.
Connect the intelligent tester (with can vim) to the
dlc3 ...