Toyota RAV4 Service Manual: Engine coolant temperature sensor

Installation

Install crankshaft position sensor Notice: Make sure that the o-ring is not cracked or jammed when installing it. Apply a light coat of engine oil to the o-ring of the sensor. ...

Removal

Drain engine coolant (see page co-6) Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal ...

Other materials:

Engine (ignition) switch (vehicles without a smart key system)
Starting the engine Check that the parking brake is set. Check that the shift lever is set in p. Firmly depress the brake pedal. Turn the engine switch to the “start” position to start the engine. Changing the engine switch positions “Lock” The steering wheel is locked an ...

Installation
Hint: Use the same procedures for the lh side and rh side. The procedures listed below are for the lh side. A bolt without a torque specification is shown in the standard bolt chart (see page ss-2). Install rear no. 1 Seat outer belt assembly lh Align the claws with the sea ...

Installation
Install mass air flow meter Install the mass air flow meter with the 2 screws. Notice: Make sure that the o-ring is not cracked or jammed when installing it. Connect the mass air flow meter connector. Connect cable to battery negative terminal ...