Starting the engine
Changing the engine switch positions
The steering wheel is locked and the key can be removed. (The key can be removed only when the shift lever is in p.)
Some electrical components such as the audio system can be used.
All electrical components can be used.
For starting the engine.
Turning the key from “acc” to “lock”
If the engine does not start
The engine immobilizer system may not have been deactivated. („_P. 76) Contact your toyota dealer.
When the steering lock cannot be released
When starting the engine, the engine switch may seem stuck in the “lock” position. To free it, turn the key while turning the steering wheel slightly left and right.
Key reminder function
A buzzer sounds if the driver’s door is opened while the engine switch is in the “lock” or “acc” position to remind you to remove the key.
Caution
When starting the engine
Always start the engine while sitting in the driver’s seat. Do not depress the accelerator pedal while starting the engine under any circumstances.
Doing so may cause an accident resulting in death or serious injury.
Caution when driving
Do not turn the engine switch to the “lock” position while driving. If, in an emergency, you must turn the engine off while the vehicle is moving, turn the engine switch only to the “acc” position to stop the engine. An accident may result if the engine is stopped while driving.
Notice
To prevent battery discharge
Do not leave the engine switch in the “acc” or “on” position for long periods of time without the engine running.
When starting the engine
Occupant classification ecu malfunction
Description
Dtc b1795 is recorded when a malfunction is detected in the occupant
classification ecu.
Troubleshoot dtc b1771 first when dtc b1771 and b1795 are output simultaneously.
Wiring diagram
Inspection procedure
Check for dtc
Turn the ignition switch on, and wait ...
Differential oil seal
Components
Replacement
Replace transaxle housing oil seal lh
Drain the automatic transaxle fluid.
Remove the drain plug and gasket, and drain
atf.
Install a new gasket and drain plug.
Torque: 47 n*m (479 kgf*cm, 35 ft.*Lbf)
Remove the front drive shaft lh (see pag ...
Open in one side of can branch line
Description
If 2 or more ecus and/or sensors do not appear on the intelligent tester's
"bus check" screen via the
can vim, one side of the can branch wire may be open. (One side of the canh
[branch wire] /canl
[branch wire] of the ecu and/or sensor is open.)
Wiring diagram
...