Description
This dtc is output when one of the following occurs: 1) the ecm detects errors in its own communications with the transponder key ecu; 2) the ecm detects errors in the communication lines; or 3) the ecu communication id between the transponder key ecu and ecm is different and an engine start is attempted. Before troubleshooting for this dtc, make sure no transponder key ecu dtcs are present. If present, troubleshoot the transponder key ecu dtcs first.
Wiring diagram
Inspection procedure
Ok: b2799 output does not reoccur.
Standard resistance
Ok: engine starts normally.
End (transponder key ecu is defective)
Installation
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
A bolt without a torque specification is shown in the
standard bolt chart (see page ss-2).
Install rear no. 1 Seat outer belt assembly lh
Align the claws with the sea ...
Before driving
Floor mat
Use only floor mats designed specifically for vehicles of the same
model and model year as your vehicle. Fix them securely in place
onto the carpet.
Insert the retaining hooks (clips)
into the floor mat eyelets.
Turn the upper knob of each
retaining hook (clip) to secure
t ...
If you have a flat tire
Your vehicle is equipped with a spare tire. The flat tire can be
replaced with the spare tire.
For details about tires
Caution
If you have a flat tire
Do not continue driving with a flat tire.
Driving even a short distance with a flat tire can damage the tire and the
wheel beyond repair, ...