Toyota RAV4 Service Manual: Evaporator temperatur sensor
Removal
- Remove air conditioning unit
- Remove the air conditioning radiator (see page ac- 185).
- Remove evaporator temperature sensor (see page ac-193)
Inspection
- Inspect evaporator temperature sensor
- Measure the resistance of the sensor.
Standard resistance 
Notice:
- Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
- When measuring, the sensor temperature must be almost the same as the ambient temperature.
Hint:
As the temperature increases, the resistance decreases (see the graph).
If the result is not as specified, replace the sensor.
Installation
- Install evaporator temperature sensor (see page ac-193)
- Install air conditioning unit
- Install the air conditioning unit (see page ac-197).
Room temperature sensor (for automatic ai conditioning system)
Components
Removal
Remove lower instrument panel
Remove the lower instrument panel (see page ip-
16).
Remove room temperature sensor
Disconnect the duct.
Disconnect ...
Solar sensor (for automatic air conditioning system)
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent ai ...
Other materials:
Making a phone call
To enter the “phone” mode, press the off-hook switch.
Making a phone call
Dialing by inputting a name
Speed dialing
Dialing by entering the number
Dialing from call histories
Receiving a phone call
Answering the phone
Refusing the call
Operations during a call
Transfer ...
Installation
Install fan and generator v belt
Using sst and 19 mm socket wrench, loosen the vribbed
belt tensioner arm clockwise, then install the
fan and generator v belt.
Sst 09216-42010
Notice:
Be sure to connect sst and the tools so that
they are in line during use.
When retracti ...
Terminals of ecm
Check ecm
Disconnect the a9 and b30 connectors.
Measure the voltage and resistance of the wire
harness side connectors.
If the result is not as specified, there may be a
malfunction on the wire harness side. ...
