Installation
Minimum length: 41.5 Mm (1.634 In.)
If the length is less than the minimum, replace the compression spring.
Notice:
Torque: 43 n*m (438 kgf*cm, 32 ft.*Lbf)
Torque: 43 n*m (438 kgf*cm, 32 ft.*Lbf)
Minimum length: 38.5 Mm (1.516 In.)
If the length is less than the minimum, replace the compression spring.
Notice:
Torque: 43 n*m (438 kgf*cm, 32 ft.*Lbf)
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.
Terminals of ecu
Skid control ecu
Hint:
*1: W/ 16-inch disc
*2: W/ downhill assist control
*3: For 2wd (w/ auto lsd)
Check skid control ecu
Disconnect the a19 ecu connector.
Measure the voltage and resistance of the wire
harness side connector.
Hint:
The voltage cannot be measured ...
Blower motor
On-vehicle inspection
Inspect blower motor (for automatic air conditioning system)
Disconnect the blower motor connector.
Connect the positive (+) lead from the battery to
terminal 1 and negative (-) lead to terminal 2, and
then check that the motor operates smoothly.
If the ...
Reassembly
Caution:
Wear protective gloves. Sharp areas on the seatback
frame, seat cushion frame and reclining adjuster may
injure your hands.
Hint:
A bolt without a torque specification is shown in the standard
bolt chart (see page ss-2).
Install rear seat cover lh
Attach the 2 claws to i ...