Toyota RAV4 (XA40) 2013-2018 Service Manual: Exterior
- Front bumper
- Rear bumper
- Radiator grille
- Ebxotdeyrior radiator grille (for 2gr-fe)
- Name plate
- Ebxotdeyrior rear spoiler
- Roof rack
- Front door belt moulding
- Rear door belt moulding
- Front pillar upper cover
- Roof drip side finish moulding
- Outside moulding
- Back door outside garnish
Installation
Install fuel filler opening lid lock retainer
Install the lock retainer and turn it counterclockwise
as shown in the illustration.
Install fuel filler opening lid lock retainer
...
Front bumper
...
Other materials:
Diagnosis system
Description
Air conditioning system data and the diagnostic
trouble codes (dtcs) can be read through the
data link connector 3 (dlc3) of the vehicle. When
the system seems to be malfunctioning, use the
intelligent tester to check for malfunctions and
perform troubleshooting.
...
Brake switch "b" circuit high
Description
The purpose of this circuit is to prevent the engine from stalling while
driving in the lock-up condition when
the brakes are suddenly applied.
When the brake pedal is depressed, this switch sends a signal to the ecm. Then
the ecm cancels the
operation of the lock-up clutch ...
Terminals of ecu
Check sliding roof drive gear subassembly (sliding roof ecu)
Disconnect the p6 ecu connector.
Measure the resistance and voltage of the wire
harness side connector.
Reconnect the p6 ecu connector.
Measure the voltage of the connector.
If the result is not as speci ...
