Toyota RAV4 Service Manual: Fail-safe chart
- Fail-safe function
- When communication fails in any of the main wires (communication lines) due to a short circuit or other causes, the fail-safe function, which is specified for each system, operates to prevent the system from malfunctioning.
- The table below shows the effects on each system when communication is impossible. For further details, refer to each system.
Hint:
: Control master ecu
: Related ecu or sensor
Hint:
: Control master ecu
: Related ecu or sensor
- Abs and traction actuator (skid control ecu) communication stop mode
- Air conditioning amplifier communication stop mode
- Power steering ecu communication stop mode
- Steering angle sensor communication stop mode
- Yaw rate sensor communication stop mode
- Ecm communication stop mode (2005/11-2006/01)
- Ecm communication stop mode (2006/01- )
- Main body ecu communication stop mode
- Combination meter ecu communication stop mode
- Center airbag sensor communication stop mode
- 4Wd control ecu communication stop mode
- Can bus line
- Open in can main wire
- Short in can bus lines
- Short to b+ in can bus line
- Short to gnd in can bus line
- Open in one side of can branch line
Diagnosis system
Bus check
Select "bus check" from the "obd / mobd
menu" screen.
Hint:
The ecus and sensors that are properly connected
to the can communication system can be di ...
Abs and traction actuator (skid control ecu) communication stop mode
Description
Wiring diagram
Inspection procedure
Notice:
Turn the ignition switch off before measuring the resistances
of the main wire and the branch
wire.
After the ignition swi ...
Other materials:
Blower unit
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove upper instrument panel
Remove the upper ...
Tilting up and down
Tilts the moon roof up*
Tilts the moon roof down*
*: Lightly press either end of the
moon roof switch to stop the moon
roof partway.
The moon roof can be operated when
Vehicles without a smart key system
The engine switch is in the “on” position.
Vehicles with a smart k ...
Summary of the blind spot monitor
The blind spot monitor is a system that has 2 functions;
The blind spot monitor function
Assists the driver in making the decision when changing lanes
The rear cross traffic alert function
Assists the driver when backing up
These functions use same sensors.
Bsm main switch
...
