If a problem occurs in the electric power steering system, the p/s warning light will come on in the combination meter and steering power assist will be stopped, fixed at a particular point, or decreased simultaneously to protect the system.
Hint:
The amount of power assist may be decreased to prevent the motor and ecus from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the engine idling.
Installation
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
Install speed sensor front lh
Notice:
To prevent interference with other parts, do not twist
the sensor wire's painted line areas when installing
it.
Set the sensor body ...
Thermostat
Components
Removal
Remove no. 1 Engine under cover
Drain engine coolant (see page co-6)
Remove radiator support opening cover
Disconnect no. 2 Radiator hose
Remove water inlet
Remove the 2 nuts and disconnect the water inlet
from the cylinder block.
Remove thermostat
...
Downhill assist control indicator light remains on
Description
When the downhill assist control switch is pushed on, the downhill assist
control function is available and
the downhill assist control indicator light illuminates.
Hint:
Even if the downhill assist control switch is pressed, the downhill assist
control indicator light will blink ...