Toyota RAV4 (XA40) 2013-2018 Owners Manual: For owners
- Reporting safety defects for u.S. Owners
- Seat belt instructions for canadian owners (in french)
- Srs airbag instructions for canadian owners (in french)
Items to initialize
The following items must be initialized for normal system operation
after such cases as the battery being reconnected, or maintenance
being performed on the vehicle:
...
Reporting safety defects
for u.S. Owners
If you believe that your vehicle has a defect which could cause a
crash or could cause injury or death, you should immediately
inform the national highway traffic safety administration
(nhtsa) in a ...
Other materials:
Position initialization incomplete
Description
This dtc is output when the sliding roof drive gear (sliding roof ecu) has
not been initialized.
Wiring diagram
Refer to dtc b2341 (see page rf-11).
Inspection procedure
Initialize sliding roof drive gear sub-assembly (sliding roof ecu)
Check that the sliding roof ...
Installation
Replace roof carrier seal
Remove the seals.
Install new seals as shown in the illustration.
Install roof rack leg front lh
Install the leg cushion front.
Install the roof rack leg front with the 2 screws.
Torque: 2.8 To 5.0 N*m (29 to 51 kgf*cm, 25 to 44
in.*Lbf)
...
Front lower ball joint
Components
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove front wheel
Remove front speed sensor lh (for 2wd) (see
page bc-191)
Remove front brake cylinder assembly lh
(see page br-40)
Remove front ...
