Toyota RAV4 Service Manual: For vehicles equipped with catalytic converter caution:
If a large amount of unburned gasoline or gasoline vapors flow into the converter, it may cause overheating and create a fire hazard. To prevent this, observe the following precautions.
- Use only unleaded gasoline.
- Avoid idling the engine for more than 20 minutes.
- Avoid performing unnecessary spark jump tests.
- Perform a spark jump test only when absolutely necessary. Perform this test as rapidly as possible.
- While testing, never race the engine.
- Avoid a prolonged engine compression measurement. Engine compression measurements must be performed as rapidly as possible.
- Do not run the engine when the fuel tank is nearly empty. This may cause the engine to misfire and create an extra load on the converter.
When towing active torque control 4wd vehicles
Use one of the methods shown below to tow the
vehicle.
If the vehicle has trouble in the chassis and drivetrain,
use method 1 (flat bed truck).
Notice:
Do not use any towing method ot ...
Inspection and adjustment of joint angle during removal and
installation of propeller shaft (4wd)
When performing operations which involve the
removal and installation of the propeller shaft,
always check the joint angle. Make adjustments if
necessary (see page pr-4).
...
Other materials:
No signal from transmitter id
Description
The tire pressure warning valve and transmitter constantly sends radio waves
to the tire pressure warning
ecu.
Under the following conditions, the tire pressure warning antenna and receiver
is unable to receive the
signals from the tire pressure warning valve and transmitte ...
Dtc check / clear
Check dtc
Connect the intelligent tester to the dlc3.
Turn the ignition switch on and turn the tester on.
Select the following menu item: body / sliding roof /
dtc.
Check the dtc(s).
Clear dtc
Connect the intelligent tester to the dlc3.
Turn the ignition switch on ...
Engine control system malfunction
Description
If a malfunction in the engine control system is detected, the operations of
vsc and trc are prohibited
by the fail-safe function. When the signals from the engine are input normally,
the fail-safe is canceled and
the dtc is not stored.
Inspection procedure
Check harn ...
