Toyota RAV4 Service Manual: For vehicles equipped with vehicle stability (vsc) system
- Notices when using drum tester
- Before beginning testing, disable the vsc. To disable the vsc, turn the ignition switch off and connect sst to terminals 12 (ts) and 4 (cg) of the dlc3.
Sst 09843-18040
Notice:
- Confirm that the vsc warning light blinks.
- Vsc system will be reset when the engine is started.
- For safety, secure the vehicle with restraint chains while using a wheel dynamometer.
- Notices of related operations to vsc
- Do not carry out unnecessary installation and removal as it might affect the adjustment of vsc related parts.
- Be sure to follow the instructions for work preparation and final confirmation of proper operation of the vsc system.
For vehicles equipped with mobile communication systems
Install the antenna as far away from the ecu and
sensors of the vehicle electronic systems as
possible.
Install an antenna feeder at least 20 cm (7.87 In.)
Away from the ecu and sensors ...
When servicing active torque control 4wd vehicles
The active torque control 4wd rav4 is equipped
with the 4 wheel drive control system.
If incorrect preparations or test procedures are
used, the test will not only be unsuccessful, but may
...
Other materials:
System description
Engine immobiliser system description
The engine immobiliser system is designed to prevent
the vehicle from being stolen. This system uses a
transponder key ecu that stores the key codes of
authorized ignition keys. If an attempt is made to start
the engine using an unauthorized key, the e ...
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Disconnect cable from positive battery
terminal
Remove battery clamp
...
Daytime running light relay
On-vehicle inspection
Inspect day time running light relay
Remove the no. 2 Relay, no. 3 Relay and no. 4 Relay
from the engine room no. 2 Relay block.
Measure the resistance of the relays.
Standard resistance:
No. 2, No. 4
No. 3
If the result is not as specified, replace th ...
