Toyota RAV4 Service Manual: Front door belt moulding

Installation

Replace roof carrier seal Remove the seals. Install new seals as shown in the illustration. Install roof rack leg front lh Install the leg cushion front. Install the roof ...

Removal

Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Notice: Wait at least 90 sec ...

Other materials:

Audio system
Operations such as listening to audio, using the hands-free phone, confirming vehicle information and changing audio system settings are started by using the following buttons. Audio system operation buttons “Audio” button Display the “select audio source” screen or audio top s ...

Replacement
Replace generator drive end frame bearing Remove the 4 screws and bearing retainer. Using sst and a hammer, tap out the bearing. Sst 09950-60010 (09951-00250), 09950-70010 (09951-07100) Using sst and a press, press in a new bearing. Sst 09950-60010 (09951-00250), 09 ...

Installation (2006/01- )
Install front drive shaft assembly lh Coat the spline of the inboard joint shaft with gear oil. Align the shaft splines and tap in the drive shaft with a brass bar and hammer. Notice: Set the snap ring with the opening side facing downwards. Be careful not to damage the ...