Inspection
Ok
If the result is not as specified, replace the door lock assembly.
Standard resistance
If the result is not as specified, replace the door lock assembly.
Standard resistance
If the result is not as specified, replace the door lock assembly.
Ok
If the result is not as specified, replace the door lock assembly.
Standard resistance
If the result is not as specified, replace the door lock assembly.
Switch failure
Description
This dtc is output when the sliding roof drive gear (sliding roof ecu)
detects that the slide open or
tilt up switch in the overhead junction block is stuck for 30 seconds or more.
Wiring diagram
Refer to dtc b2341 (see page rf-11).
Inspection procedure
Read value of i ...
Diagnostic trouble code chart
Hint:
Parameters listed in the chart may be different than your
readings depending on the type of instrument and other
factors.
If any dtcs are displayed during a check mode dtc check,
check the circuit for the dtcs listed in the table below. For
details of each dtc, refer to the page indica ...
Check for open circuit
For an open circuit in the wire harness in fig. 1,
Check the resistance or voltage, as described below.
Check the resistance.
Disconnect connectors a and c, and measure
the resistance between them.
Standard resistance (fig. 2)
Hint:
Measure the resistance while lightly s ...