Toyota RAV4 (XA40) 2013-2018 Service Manual: Front drive shaft assembly (for 4wd)

Installation (2006/01- )

Install front drive shaft assembly lh Coat the spline of the inboard joint shaft with gear oil. Align the shaft splines and tap in the drive shaft with a brass bar and hammer. No ...

Removal (2005/11-2006/01)

Remove front wheel Drain automatic transaxle fluid Drain the automatic transaxle fluid for u140f (see page ax-147). Drain the automatic transaxle fluid for u241e (see page ax-146). ...

Other materials:

Body
General maintenance Tighten bolts and nuts Tighten the bolts and nuts on the chassis parts listed below, if necessary. Front axle and suspension Drivetrain Rear axle and suspension Brake system Engine mounting Other chassis parts Tighten the bolts and nuts on the bo ...

AHB (Automatic High Beam)
The Automatic High Beam uses an in-vehicle front camera to assess the brightness of streetlights, the lights of vehicles ahead etc., and automatically turns the high beams on or off as necessary. WARNING â– Limitations of the Automatic High Beam Do not overly rely on the Automatic High Beam. Always ...

Rear occupant classification sensor rh collision detection
Description Dtc b1788 is output when the occupant classification ecu receives a collision detection signal sent by the rear occupant classification sensor rh when an accident occurs. Dtc b1788 is also output when the front seat rh is subjected to a strong impact, even if an actual acci ...