Adjustment
Notice:
Before inspecting the wheel alignment, adjust the vehicle height to the specification.
Standard vehicle height (unloaded vehicle)
Hint:
Standard toe-in (unloaded vehicle)
If the toe-in is not as specified, adjust it at the rack ends.
Standard difference: 1.5 Mm (0.059 In.) Or less
Torque: 55.5 N*m (566 kgf*cm, 41 ft.*Lbf)
Hint:
Make sure that the boots are not twisted.
Standard wheel angle (unloaded vehicle)
If the angles are not as specified, check and adjust the right and left rack end lengths.
Standard camber inclination (unloaded vehicle)
Standard caster inclination (unloaded vehicle)
Hint:
*: W/ 3rd seat
Standard steering axis inclination (unloaded vehicle)
Notice:
After the camber has been adjusted, inspect the toein.
Torque: 240 n*m (2,447 kgf*cm, 177 ft.*Lbf)
Torque: 103 n*m (1,050 kgf*cm, 76 ft.*Lbf)
If the measured value is not within the specified range, calculate the required adjustment amount using the formula below.
If the camber is not within the specification, estimate how much additional camber adjustment will be required and select the camber adjusting bolt using the following table.
Hint:
Replace 1 bolt at a time when replacing 2 bolts.
Opening and closing procedures
The power windows can be opened and closed using the switches.
Operating the switch moves the windows as follows:
Closing
One-touch closing (driver’s window
only) (if equipped)*
Opening
One-touch opening (driver’s
window only)*
*: To stop the window partway, operate
the ...
Using the mechanical key (vehicles with a smart key system)
To take out the mechanical key,
push the release button and take
the key out.
The mechanical key can only be
inserted in one direction, as the
key only has grooves on one side.
If the key cannot be inserted in a
lock cylinder, turn it over and reattempt
to insert it.
After using the mec ...
Speaking on the phone
The following screen is displayed when speaking on the phone.
To adjust the call volume
Select “-” or “+”. You can also adjust the volume using the steering
switches or the volume knob.
To prevent the other party from hearing your voice
Select “mute”.
Inputting tones
When usin ...