Toyota RAV4 (XA40) 2013-2018 Service Manual: Front wiper motor
Inspection
- Inspect front wiper motor
- Check the lo operation.
- Connect the battery's positive (+) lead to terminal 5 (+1) and the negative (-) lead to terminal 4 (e), and check that the front wiper motor operates at low speed (lo).
Ok: front wiper motor operates at low speed (lo).
If the result is not as specified, replace the motor.
- Check the hi operation.
- Connect the battery's positive (+) lead to terminal 3 (+2) and the negative battery (-) lead to terminal 4 (e), and check that the front wiper motor operates at high speed (hi).
Ok: front wiper motor operates at high speed (hi).
If the result is not as specified, replace the motor.
- Check the automatic stop operation.
- Connect the battery's positive (+) lead to terminal 5 (+1) and the negative (-) lead to terminal 4 (e). With the motor rotating at low speed (lo), disconnect the lead from terminal 5 (+1) to stop the wiper motor operation at any position other than the automatic stop position.
- Using sst, connect the terminals 1 (+s) and 5 (+1). Then connect the battery's positive (+) lead to terminal 2 (b) to restart the motor operation at low speed (lo).
- Check that the motor stops automatically at the automatic stop position.
Ok: refer to the illumination.
If the result is not as specified, replace the motor.
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in order of probability in the "suspected area" column of
th ...
Front wiper motor and link
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent ai ...
Other materials:
For safe driving
For safe driving, adjust the
seat and mirror to an appropriate
position before driving.
Correct driving posture
Adjust the angle of the seatback
so that you are sitting
straight up and so that you do
not have to lean forward to
steer.
Adjust the seat so that you
can depress the pedals full ...
Open in pump motor circuit
Description
The motor relay drives the pump motor based on a signal from the skid control
ecu.
Wiring diagram
Refer to dtc c0273/13, c0274/14, c1361/91 (see page bc-79).
Inspection procedure
Perform active test by intelligent tester (motor relay)
Select the active test, gener ...
Cruise control switch circuit
Description
This circuit sends signals to the ecm depending on the cruise control switch
condition. The battery
supplies positive (+) battery voltage to the cruise control switch. Then
terminal ccs of the ecm receives
the voltage according to the switch condition.
Wiring diagram
Inspect ...
