Components
Removal
Notice:
Do not fold the wiper arm with the wiper blade removed. The arm tip may damage the windshield surface.
Notice:
Do not pull out the wiper rubber forcibly. Doing so will deform the backing plate or damage the blade claw.
Installation
Notice:
Install the packing plates facing the proper direction.
Hint:
Install the wiper rubber so that the head part (large side) of the wiper rubber faces the arm axle side.
Notice:
Push the wiper blade into the grooves of the wiper rubber to attach them completely.
Removal (2005/11-2006/01)
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove roof headlining assembly
Remove the roof headlining (see page ir ...
Camshaft position correlation (bank 1 sensor a)
Dtc P0016 P0016 crankshaft position - camshaft position correlation
(bank 1 sensor a)
Description
In the vvt (variable valve timing) system, the appropriate intake valve open
and close timing is
controlled by the ecm. The ecm performs intake valve control by performing the
following: 1) cont ...
Solenoid circuit
Description
This solenoid is turned on in accordance with signals from the skid control
ecu and controls the pressure
on the wheel cylinders to control the braking force.
The solenoid and solenoid relay are built into the abs and traction actuator.
Hint:
Dtcs c0226/21, c0236/22, c02 ...