Toyota RAV4 Service Manual: Fuel pressure pulsation damper
Components
Removal
- Discharge fuel system pressure (see page fu-9)
- Disconnect cable from negative battery terminal
- Remove no. 1 Engine cover (see page es-410)
- Remove air cleaner cap sub-assembly (see page es-411)
- Disconnect fuel main tube (see page fu-10)
- Remove fuel pressure pulsation damper assembly
- Remove the 2 bolts and fuel pressure pulsation damper.
Installation
- Install fuel pressure pulsation damper assembly
- Apply a light coat of gasoline or spindle oil to the oring of the fuel pressure pulsation damper.
- Install the fuel pressure pulsation damper with the 2 bolts.
Torque: 9.0 N*m (90 kgf*cm, 80 in.*Lbf)
Notice:
Make sure that the o-ring is not cracked or jammed when installing.
- Install fuel main tube (see page fu-14)
- Install air cleaner cap sub-assembly (see page es-413)
- Install no. 1 Engine cover (see page es-414)
- Connect cable to battery negative terminal
- Check for fuel leaks (see page fu-14)
Fuel pressure regulator
Components
Removal
Remove fuel tank assembly
Remove the fuel tank (see page fu-39).
Remove fuel tank main tube sub-assembly
Remove the joint clip and fuel tank main tube ...
Fuel pump
Components
Removal
Remove fuel tank assembly
Remove the fuel tank (see page fu-39).
Remove fuel tank main tube sub-assembly
Remove the joint clip and fuel tank main tube ...
Other materials:
Display settings
Settings are available for adjusting the contrast and brightness
of the screen.
Screen for display settings
Press the “setup” button.
Select “display” on the “setup” screen.
Adjust the screen display
Adjust the camera display*
Changes to day mode.
*: If equipped
...
Connecting a bluetooth®
device
Up to 5 bluetooth® devices (phones (hfp) and audio players
(avp)) can be registered.
If more than 1 bluetooth® device has been registered, select
which device to connect to.
Press the “setup” button.
Select “bluetooth*”.
*: Bluetooth is a registered trademark of bluetooth sig ...
Rear drive shaft assembly
Components
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery termin ...
