Toyota RAV4 Service Manual: Hazard warning switch
Components
Removal
- Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- Remove no. 1 Instrument cluster finish panel center (see page ip-5)
- Remove hazard warning signal switch assembly
- Detach the 2 claws and remove the switch.
Inspection
- Inspect hazard warning signal switch assembly
- Measure the resistance of the switch.
Standard resistance
If the result is not as specified, replace the switch assembly.
- Inspect the switch illumination.
- Connect the battery positive (+) lead to terminal 3 (ill+) and the negative (-) lead to terminal 2 (ill-), then check that the light comes on.
Ok: led comes on.
If the result is not as specified, replace the light.
Installation
- Install hazard warning signal switch assembly
- Attach the 2 claws to install the switch.
- Install no. 1 Instrument cluster finish panel center (see page ip-10)
- Connect cable to negative battery terminal
Headlight dimmer switch
Precaution
Precaution for vehicle with srs
Some procedures in this section may affect the
supplemental restraint system (srs). Prior to
performing the procedures, read the srs section's
...
Front door courtesy switch
Components
Removal
Hint:
Use the same procedures for the rh and lh sides.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Cautio ...
Other materials:
Contact/call history
settings
The contact can be transferred from a bluetooth® phone to the system.
The contact also can be added, edited and deleted.
The call history can be deleted and contact and favorites can be
changed.
Display the “phone/message settings” screen.
Select “contact/call history settings” ...
Rear no. 1 Suspension arm
Components
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove rear wheel
Remove rear no. 1 Suspension arm assembly lh
Support the no. 2 Suspension arm lh.
Remove the bolt and 2 nuts from t ...
System diagram
System diagram (2005/11-2006/01)
System diagram (2006/01- )
...
