Description
When the hazard warning signal switch is turned on, the turn signal flasher relay (marking: flsh) in the main body ecu turns on to flash the hazard warning signal lights.
Wiring diagram
Inspection procedure
Ok: all hazard warning signal lights flash.
Standard resistance: below 1
Standard voltage
Ok: all hazard warning signal lights flash.
Replace turn signal flasher relay
Standard resistance
Repair or replace harness and connector (hazard warning signal switch - body ground)
Solar sensor (for automatic air conditioning system)
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove solar sensor
Using a screwdriver, p ...
Sruepsptrleaminetnstal restraint system center airbag sensor assembly
Components
On-vehicle inspection
Check center airbag sensor assembly
(vehicle not involved in collision and
airbag not deployed)
Perform a diagnostic system check (see page rs-
49).
Check center airbag sensor assembly
(vehicle involved in collision and airbag
not deplo ...
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Disconnect cable from negative battery terminal
Notice:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and se ...